Fitting the DualGuard

The DualGuard has been designed to be fitted in just a few easy steps, to show how simple the process is we have put together a video or you can look through the photos and the following fitting instructions:

When fitting the DualGuard please make sure the lower section is fitted first. Once you have positioned the lower section correctly, feed the zip ties through the holes and down the gap between the frame and cross section of the chain stay.
When the ties are in position make sure the DualGuard is pulled TIGHT against the chainstay giving maximum clearance for the tyre.
The zip tie fastener should be just under the bottom of the chainstay cross section to give maximum clearance, once happy with the positioning tighten up the zip ties on the side of the chainstay.

On the latest model of the Levo it comes with a little plastic protector, this needs to be removed as shown in this video.

Step 1: Place the smaller half in the following position

Due to variations on the rubber frame protector you may need to trim the DualGuard to prevent chain rubbing.


Step 1: Place the smaller half in the following position
Step 2: Secure the smaller half with the included zip ties, using the holes provided as show.

Step 2: Secure the smaller half with the included zip ties, using the holes provided as shown.
Step 3: Place the larger half in the following position and using the remaining zip ties secure in place as shown
Step 4: When properly assembled the two pieces should properly align, ensure the larger half is closer the tire on the inside.

Step 4: When properly assembled the two pieces should properly align, ensure the larger half is closer the tire on the inside.
Step 5: The DualGuard is successfully fitted.